DNP
DNP Retransfer print format
The print range on Retransfer film is bigger than actual print range on the card. Following figure shows it. There should be a marging of 1.0±0.5mm on each side of the card.
How to add color conversion to DNP
1. Make sure to install Color Conversion Data during printer driver installation. 2. Open Printer preferences and check Enable the look-up table 3. Select Enable the look-up table settings. 4. Click select button then change extension from .CSV to ...
How to test print in DNP CX-D80
How to get DNP Printer Logs
1. Run latest CX-D80 Maintenance tool as administrator. (CX-D80_MT(18_12_26_0) 2. Select Printer select 3. Select Exit 3. Select logs 4. Select Output logs and click ok. 5. drag to select all logs then copy all text and paste it on notepad then save.
How to get firmware of DNP CX-D80
1. Open Status monitor 2. Go to Property Tab and take a screenshot.
DNP printer Transport Mode
Transport mode When transporting or moving the printer, ensure that the heating roller is fastened to a safe position by turning on Transport mode. Make sure that you set the printer to transport mode when transporting or moving the printer. Failure ...
How to get Firmware version of DNP
1. Open Status monitor Note: If your printer is CX-D80DS use CX-D80 Status monitor. If your printer is CX-D80HS use CX-D80H Status monitor. 2. Go to Property tab.
How to adjust layout for DNP printer
This is an illustration how DNP prints the layout The DNP Printer cuts the layout and prints only the inner side of the border. The outter side of the border stays on the retransfer film. For your layout to be fitted. Make sure to adjust your layout ...
DNP CX-D80 - Printer setup, installation and basic printing
DNP CX-D80DS - How to replace ribbon