How to test print in DNP CX-D80

How to test print in DNP CX-D80


    • Related Articles

    • DNP Retransfer print format

      The print range on Retransfer film is bigger than actual print range on the card. Following figure shows it. There should be a marging of 1.0±0.5mm on each side of the card.

    • How to print front only with magstripe encoding - DNP CX-D80 Cardexchange

      1. In DNP CX-D80 properties, under print tab disable/uncheck "Print on both sides" 2. In Cardexchange, Select the Card template then go to Configuration tab and select Card Designer, 3. Select Back layout, and go to Page layout tab. 4. ...

    • Misaligned Printout on DNP

      Sample of Misaligned Printout To fix this, 1. Remove Retransfer cartridge 2. Look for a screw on the upper right corner of Retransfer cartridge slot. Please see below image for reference. 3. Rotate the screw counter clockwise 5 times and print a ...

    • How to add color conversion to DNP

      1. Make sure to install Color Conversion Data during printer driver installation. 2. Open Printer preferences and check Enable the look-up table 3. Select Enable the look-up table settings. 4. Click select button then change extension from .CSV to ...

    • How to get firmware of DNP CX-D80

      1. Open Status monitor 2. Go to Property Tab and take a screenshot.