How to add personnel and privileges on Access control

How to add personnel and privileges on Access control

1. How to add personnel 
  1. Click “Auto add cards by swiping” at the top left of the access control
          
  1. This should pop out
          
  1. Swipe RFID card to the card reader
          
  1. Click Ok
          
  1. Go to configuration then personnel
         
  1. Select user then Click on edit. This should pop out 
          
  1. Fill up the necessary information then click ok
         
  1. End
2. Adding privilege to the personnel
  1. Go to Configurations then Access Privilege
         
  1. Click Change Privilege, This Should Pop out
         
  1. Select the user and the door you want to add privilege on then click on both the right arrow button to put the selected to the right side 
          
  1. Click on “Allow and upload” or “Prohibit and upload”. “note: The device should be connected to the pc in order to upload"
  2. End

    • Related Articles

    • How to add controller to Access Control System

                 1. Setting IP address of PC to static Open Control panel Go to Network and Sharing Center Click Change adapter settings Right Click Ethernet and click on properties Check Internet protocol version 4(TCP/IPV4) then click properties Change ...
    • How to Import users to access control using excel

      Manually adding users to the access control can be repetitive and tiring and takes time. Importing users to access control can help you solve this problem. Here is a quick tutorial on how to import the users into the access control. Step 1: Open ...
    • How to Generate Attendance report on Sebury Access Control

      1. Configuring the shift rules of the schedule. Click on attendance at the left side of the access control then click the normal shift rules. This should pop out              Adjust the parameters according to your  shift schedule then click "ok" end ...
    • Anviz - How to add device to Crosschex Video Tutorial

      How to add Anviz Biometrics to Crosschex
    • How to add color conversion to DNP

      1. Make sure to install Color Conversion Data during printer driver installation. 2. Open Printer preferences and check Enable the look-up table 3. Select Enable the look-up table settings. 4. Click select button then change extension from .CSV to ...