Magicard Printers - Safety Instructions

Magicard Printers - Safety Instructions


SAFETY INSTRUCTIONS:
To prevent electric shock do not remove covers.
Do not attempt to service the printer yourself.
There are no user serviceable parts inside. In the event of malfunction, refer servicing to your printer’s supplier.
Use only a power source within the limits marked on the bottom panel.
Take care not to spill any liquid on the printer.
Ensure that the power supply cord is no longer than 2 metres in length and includes a properly grounded connection.

    • Related Articles

    • Magicard Drivers - Download and Installation Guide

      Download the Magicard Driver first, go to this link https://support.magicard.com/solution/driver/ For Magicard Neo, go to this link https://support.magicard.com/solution/magicard-neo-printer-driver/ After downloading the drivers follow the ...
    • MAGICARD ID PRINTER CAN'T DETECT? (step by step troubleshooting guide)

      1. Please check the printer if it's turned on. if not, please check if the power cable is not loosen or it is fitted on your power outlet the adapter should have a light indicating that the adapter has a power. if you don't see a light on the adapter ...
    • Magicard ID Printer - Can't print on the CardExchange Software or Can't print directly

      This is the screenshot in (Devices and Printers) As you can see on the picture above there are 4 Magicard Enduro don't get confused because the highlighted one is the printer driver that you are using right now. - Magicard Enduro3E (V2) Because the ...
    • Magicard Pronto 100 ID Card Printer

      Card Printer Magicard Pronto 100 Magicard Pronto 100 Thermal ID printer is where you can print erase and reprint up to 50 times on a single card without using an ink ribbon. set up the ID printer  first is remove the ribbon inside and close the door ...
    • Faded image output - Magicard ID Printer

      1.Power supply  - Check the power supply wattage and voltage output, if it's match to the required power of printer. 2.Printhead power - try to increase the printhead power, Go to image then printhead power options, and try to increase the color ...