DNP Retransfer print format

DNP Retransfer print format

Info
The print range on Retransfer film is bigger than actual print range on the card. Following figure shows it.
There should be a marging of 1.0±0.5mm on each side of the card.


    • Related Articles

    • How to print dual sided to Magicard Printer via Windows Print

      1. Select Options 2. Select Printer Properties 3. Select Both sides 4. Select your desired Color Format for Front and Back layout. 1. Color / Composite black (YMC) means you will print black color using Yellow / Magenta / Cyan ribbon panels and ...

    • Dual sided print settings of CardExchange

      1.Click Printer options. 2. Look for the device connected then click OK. 3.Click Printer properties 4. Check the Duplex printing click both sides Click apply. 5.Click Card Front /Card back Select your prefered Color format for your layout click ...

    • How to adjust layout for DNP printer

      This is an illustration how DNP prints the layout The DNP Printer cuts the layout and prints only the inner side of the border. The outter side of the border stays on the retransfer film. For your layout to be fitted. Make sure to adjust your layout ...

    • How to test print in DNP CX-D80

    • Misaligned Printout on DNP

      Sample of Misaligned Printout To fix this, 1. Remove Retransfer cartridge 2. Look for a screw on the upper right corner of Retransfer cartridge slot. Please see below image for reference. 3. Rotate the screw counter clockwise 5 times and print a ...